![]() Open your Terminal application either through the system Application Launcher Search or through the Ctrl+Alt+T shortcut. ![]() This depends which value you have within your sktop file on line 4: Exec=xscreensaver -nosplash. Install Xscreensaver The Xscreensaver package is available in the official Ubuntu repositories (ubuntu-bionic-universe) and can easily be installed through the command line using the apt-get command. On my computer it's in /etc/xdg/autostart/sktop, then open it in an editor (terminal 'nano' may be best as you will need sudo commands to open it) and change 'Applicaton' to 'Application'.Īlso, different tutorials (such as liberiangeek and Radu's response) suggest using: "xscreensaver -nosplash"Īs the fix above uses. This should, somewhere in the list, tell you where sktop is. To find out if this is the issue: first run locate sktop. Into your startup list, it would not work as xscreensaver is not set up with the type application. Therefore, if you have already entered the command "xscreensaver -no-splash" This causes the startup command to not work. 'Application' has been misspelt as 'Applicaton'. Canonical will also work in concert with Microsoft’s new distro maintainer. However, for some reason, in many of these tutorials, the above command is incorrect. NET 6 packages on Ubuntu with a single, simple command: sudo apt install dotnet6 Canonical and Microsoft built this. They tell you to set up a sktop file with the following command: sudo gedit /etc/xdg/autostart/sktopĪnd then place inside it the following information: As no answer has been marked as correct yet this could be this issue with running xscreensaver on startupĪs says here, many of the tutorials for setting up xscreensaver provide incorrect information.
0 Comments
Leave a Reply. |